Basicly switch-independanmt teaming with a active/standby configuation. Again LACP/trunking can not be used as it involves diffrent switch stacks. If the link to the primary 元 core switch stack fails the link to the backup 元 core switch stack becomes active instead. When enabling the wireless access list, it will ONLY allow list of mac address listed in the router settings. As it is between different switch stacks, LACP/Trunking can not be used.Įssentialy I want the PA-220 to have a single link to our primary core switch stack and a single link our backup core switch stack, but only a single IP for the interface. That way only the IP phones based on their MAC address will be able to use the PA-220 as a default gateway out.Īlso (and if so how), can one create a failover/floating interface from the PA-220 that goes to separate core switch stacks, with one being active and the other being inactive unless the primary fails. Ideally using a wild card filter for MAC addresses beginning with a known value. What I want to know is it possible (and if so how) to configure a source MAC address white-list filter on the PA-220 so only authorised devices will be able to use the PA-220 as their default gateway. The IP phones will use a interface on the PA-220 as their default gateway. ![]() At my work place we have a new single PA-220 firewall router that I am configuring to be used as a router/gateway out for SIP traffic. ![]() ![]() Hi all, I am new here so sorry if this is in the wrong place.
0 Comments
Leave a Reply. |